Anybus Wireless Bridge II 설치 매뉴얼 - 페이지 10

{카테고리_이름} Anybus Wireless Bridge II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anybus Wireless Bridge II 17 페이지.

페이지 인쇄

Configuration

4.2

Easy Config

Power on the unit and wait for the Link Quality LEDs to light up and go out

again, then press and release the MODE button.

Step 1 must be carried out within 5 seconds of startup.

Press MODE repeatedly to cycle through the Easy Config modes until the

desired mode is indicated by the A-B-C-D LEDs.

Mode 2 is the first mode, which means that the number of required button

presses are always one less than the mode number.

Press and hold MODE for 2 seconds, then release the button. This will con-

firm the selected mode and restart the unit.

Step 3 must be carried out within 20 seconds of step 2, otherwise the unit

will exit Easy Config setup and return to the previous settings.

4.2.1 Easy Config Modes

Mode

Modes 4, 5 and 6 are used in combination to automatically set up a WLAN or

Bluetooth network with units of this type.

Modes 5 and 6 will scan for units in Mode 4. Each detected unit in Mode 4 will be

reconfigured as a client, and the scanning unit will be configured as an access

point. The clients will then restart and connect to the access point.

Mode Timeout

•

Mode 5 and 6 will scan for 120 seconds. The mode can be activated repeat-

edly to scan for additional units.

•

Mode 4 will listen for 120 seconds, or until it has received a valid configura-

tion from a unit scanning in Mode 5 or 6.

Anybus

Wireless Bridge II

Role

Description

—

Reset configuration to factory defaults

—

Reset IP settings to factory defaults

Client

Wait for discovery and configuration

WLAN AP

Discover units in Mode 4 and configure

them as clients

Bluetooth NAP

The IP address of a client may be changed by the configuration from the

access point. Active browser sessions could therefore be lost.

™

Installation Guide

10 (16)

SCM-1202-013/SP2167 1.1