ADDER AdderLink X100 사용자 설명서 - 페이지 11

{카테고리_이름} ADDER AdderLink X100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ADDER AdderLink X100 19 페이지. Extender set
ADDER AdderLink X100에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

Hot plugging and mouse restoration

It is strongly recommended that you switch off the computer system before

attempting to connect the local device and X100 receiver. However, if this is not

possible then you need to 'hot plug' the local device and X100 receiver while

power is still applied to the system. There is not normally a danger of damage

to the system, however, when mouse communications are interrupted, often

they fail to reinitialise when reconnected. The X100 receiver provides a feature

to reinstate mouse communications once the necessary connections have been

made.

There are two main types of data formats used by current PC mice, these are

the older 'PS/2' format and the more recent 'IntelliMouse

by Microsoft. These use slightly different data arrangements and it is important

to know which type was being used before you hot-plugged the local device

and X100 receiver. The previous setting depends both on the type of mouse and

the type of driver as various combinations of PS/2 and Intellimouse are possible.

Using the incorrect restore function may produce unpredictable results and

require the system to be rebooted.

Which restore setting do I use?

The general rule is that unless both the mouse and the driver are both

Intellimouse compatible then you need to restore the mouse as 'PS/2'.

Recognising an Intellimouse-style mouse

The Intellimouse format was introduced to support, among other features, the

scroll wheel function. If your mouse has a scroll wheel, then it is likely to support

the Intellimouse format. If you have a Microsoft mouse, then it will usually state

that it is an Intellimouse on its underside label.

Recognising an Intellimouse driver

Before hot plugging (or afterwards using only keyboard control), access the

Windows Control Panel and select either the Mouse option (on Windows NT,

2000 and XP) or the System option (on Windows 95, 98, ME). Look for the

name of the driver, which will usually include the words PS/2 or Intellimouse.

To restore mouse operation when hot plugging:

1 Carefully connect the local device and the X100 receiver to the system and

its keyboard, mouse, monitor and speakers.

2 Simultaneously, press the hotkeys (by default,

to enter configuration mode.

3 Enter the appropriate restore function code:

4 To exit configuration mode, press

' format introduced

5 Move the mouse a short distance and check for appropriate on-screen

cursor movement. If the mouse cursor darts erratically around the screen,

then cease moving the mouse. This is an indication that the chosen restore

function is incorrect. Try again using the other restore function.

Note: The restore functions predict the likely mouse resolution settings but

may not restore the exact speed or sensitivity settings that were originally

set.

Microsoft and Logitech -specific mouse settings

In certain installations some Logitech mouse drivers may lose the action of the

mouse buttons when used with the standard 'Microsoft compatible' signalling

protocol used between the modules. To solve this problem, select the 'Logitech

compatible' mouse signalling protocol.

To change mouse signalling protocols

1 Simultaneously, press the hotkeys (by default,

to enter configuration mode.

2 Enter the appropriate protocol code:

3 To exit configuration mode, press

• PS/2 – press

• IntelliMouse – press

• Microsoft compatible – press

• Logitech compatible – press

and

) along with

and

) along with