Airush Starboard Freewing Air 7 사용자 설명서 - 페이지 16

{카테고리_이름} Airush Starboard Freewing Air 7에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airush Starboard Freewing Air 7 20 페이지.

R E P A I R S

You will be able to use the repair kit enclosed in the wing bag.

Note: If the leak is too big, please contact a kite repair professional.

Before proceeding with any kind of repair, it's important to follow the

following steps:

• Repair it in a place that is sheltered from sand, water and wind. Use a clean and ﬂat

surface to work on.

• Surfaces will need to be cleaned with freshwater or preferably alcohol.

• You will need the repair kit supplied and a marker.

R E P A I R O N T H E L E A D I N G E D G E

When you have a leak on the leading edge or central strut, it's important to follow

the next steps; taking out the bladder from the wing, locate the leak on the

bladder and mark it, repair with the rubber patch and ﬁnally put the bladder

inside again. Pump it softly until the bladder is perfectly mounted.

1. LOCATE THE LEAK WITH THE BLADDER MOUNTED:

Pump the wing and try to hear where the leak is located, pay special attention

around the valve area. In case you cannot hear the leak, you can spray water onto

the leading edge and strut. You will see bubbles popping out where the leak is. We

do this step ﬁrst before dismounting the bladder as sometimes the leak may occur

very next to the tips or the zipper. In this case, the repair can be completed with

the bladder mounted on the wing, you can skip steps 2 and 4 if this is your

situation. If the leak is not close to these areas or we simply don't detect the leak

then we need to remove the bladder.

- 16 -