Anysecu WP-67 사용자 설명서 - 페이지 7

{카테고리_이름} Anysecu WP-67에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anysecu WP-67 10 페이지. Ip67 water-proof two-way radio

User Manual of WP-67 Water-proof Two-way Radio

much noises, long-time transmitting may occur after the VOX function is activated.

◆Busy channel lockout

This function is helping to interrupt other radio which is working, if the channel is occupied, then transmitting is forbidden.

there are two setting of this function for WP-67:

1) Carrier: if the channel is occupied, then transmitting is forbidden.

2) QT/DQT: if the channel is occupied, Received the same QT/DQT, , then transmitting is allowed.

if QT/DQT different, then transmitting is forbidden.

◆Squelch level setting

You can adjust the squelch level of the two-way radio by programming; screen out with weak signal or channel if the background noise is higher

than common value.

▲When the squelch level is set as o or too low, the two-way radio is easy to be interrupted by useless call with weak signal; when the squelch

level is set too high, call from remote position may also be screened out.

◆TOT (Time-out time)

The TOT function 0-270s can be set by software prevents any caller from occupying too long channel time. Limit the user's over time transmit,

and avoid the risk of damage to walkie talkie due to long time transmit.

◆bandwidth setting

You can set every channel wide/narrow band by computer

◆ANI ID

Wp-67 allow users use ANI identification through DTMF, there are 4 way

OFF: press/release PTT will not send DTMF code

PRE-ONLY: press PTT will send DTMF code

POST-ONLY: release PTT will send DTMF code

BOTH: press&release PTT will send DTMF code

◆Tail tone elimination

Tail tone elimination avoiding the impact noise made by the speaker after the call to protect users from such noise impact. After transmit over,

all same frequency radio in valid distance can listen"du",means transmit over.the function can be opened / closed by software.

◆Battery save

The battery saving function can make the interphone reduce the work of the receiving circuit without signal reception, thus prolonging the use

time of the interphone, the function can be opened / closed by software.

◆program password

You can set password to read/write frequency

CTCSS and CDCSS are mainly used to avoid receiving irrelevant calls in the same frequency. If CTCSS/CDCSS is set, only calls for which the

same CTCSS signaling is set in the channel within the effective communication range can be received; but if CTCSS/CDCSS isn't set, all calls in

the same channel within the effective communication range can be received.

You can set the CTCSS/CDCSS signaling of this two-way radio manually via frequency writing software. CTCSS/CDCSS signaling code can be

set as any value within the range of 67.0~254.1/023~754 respectively.

- 7 -