ABTECH SAFETY SLIX 100 지침 및 유지 관리 매뉴얼 - 페이지 16

{카테고리_이름} ABTECH SAFETY SLIX 100에 대한 지침 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABTECH SAFETY SLIX 100 20 페이지. Stretcher
ABTECH SAFETY SLIX 100에 대해서도 마찬가지입니다: 지침 및 유지 관리 매뉴얼 (8 페이지)

페이지 인쇄

Recommended Fitting of Horizontal Haul

and Lifelines to the Slix 100 Stretcher

Fig. 1.

Horizontal Haul Lifeline.

Attach the Security rope A to the Vertical Haul

Points 8 using a Double Fig 8 and two screw gate

karabiners.

Fit the Horizontal Haul Strops to a screw gate

karabiner D and then each leg of the Strop to the

Horizontal Haul Points C.

NOTE! Red to Red/Blue to Blue gives

attitude. Red to Blue/Red to Blue gives a Head

Down

attitude.

Attach the Haul Rope E to the karabiner D with a

Fig 8

knot.

Link the Security rope A to the Haul rope E with a

karabiner

To avoid 3 way load attach the karabiner to

the loop of the Haul rope Fig 8 knot

NEVER into the Haul karabiner

Connecting like this

more horizontal attitude in the event of a Haul

rope or Security rope failure.

See p 14 for Important

Strop rigging information

will

keep the Stretcher in a

Fig. 1

Note that Horizontal and Vertical

Haul Strops Are Now Supplied As

Sewn Slings to EN795 19978.

Instructions for attachment and

use are the same as rope

It is essential that the karabiner

used to attach the hauling slingsl

strops are Screw Gate karabiners

to a minimum of 25kN and a gate

opening of at least 24mm.

Head Up

Damage to the edge of the

stretcher WILL occur if smaller

gate opening karabiners are

Fig. 2 colour coded 25kN Sewn

Tapes

slings.

used.