AnyTone AT-5555 PLUS 사용 설명서 - 페이지 5

{카테고리_이름} AnyTone AT-5555 PLUS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyTone AT-5555 PLUS 17 페이지. 10 meter radio

페이지 인쇄

1. WHERE AND HOW TO MOUNT YOUR RADIO

a)It is important to identify the proper place of the installation by

considering "key criteria", such as easy access and congenial

spaces with freedom of movement.

b)The radio must not compromise the comfort of either: the driver and

the passengers.

c) Remember to provide cables in harmony with safety and prevention

"standards". As well as guides their wiring in protected channels

(eg: power supply, antenna, accessory wiring), so that they do not

interfere in any way with the driving of vehicles.

d)To install your equipment, use the bracket (1) and the self-tapping

screws [2] provided (drilling diameter 5 mm). Be careful not to

damage the vehicle's electrical system when drilling the dashboard.

e)Do not forget to insert the rubber joints [3] between the radio and

its bracket as they have a cushioning effect that allows a delicate

orientation and tightening of the device.

f)Choose where to place the microphone holder and remember

that the microphone cable must extend to the driver without

interfering with the vehicle's controls.

2. ANTENNA INSTALLATION

Antenna selection:

For the best signal radiation, a well-calibrated antenna length is

very important, on the other hand, there are other factors to be

considered: the size of the vehicle and its usual speed. For this

subject you can recall for the support and patronage of your

b) Mobile antenna:

-Must be fixed to the vehicle where there is a maximum of metallic

surface(ground plane) , away from windscreen mountings.

-There are two types of antenna: Pre-Regulated Antenna which

should be used on a good ground plane (e.g. car roof or lid of the

boot), and Adjustable Antenna which offer a much

range and can be used

over

For an antenna which must be fixed by drilling, you will need a

good contact between the antenna and the ground plane. To obtain

this, you should lightly scratch the surface where the screw and

tightening star are to be placed.

-Be careful not to pinch or flatten the coaxial cable (as this runs the

risk of break down and/or short circuiting).

-Connect the antenna to location (B).

Fixed antenna:

A fixed antenna should be installed in a predominant area, possibly emerging

over the entire surrounding topography, including the canopies of trees.

Normally the antenna is raised up and fixed on the top of a mast. In some

areas, especially urban ones, it may be necessary to observe the regulations

in force in the specific region. In order to avoid unnecessary inconvenience, it

is advisable to check this matter with the authorities entrusted.

3. POWER CONNECTION

dealer.

wider

frequency

a smaller ground plane.