AnyTone D578UV 펌웨어 업데이트 지침 - 페이지 2
{카테고리_이름} AnyTone D578UV에 대한 펌웨어 업데이트 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyTone D578UV 3 페이지. Bt01 microphone
AnyTone D578UV에 대해서도 마찬가지입니다: 펌웨어 업데이트 방법 (17 페이지), 지침 (3 페이지)
페이지 인쇄
To Reset the Radio: Press and Hold the two front panel keys P2 and the Channel Knob
1)
(the one above the microphone connector) Hold these two keys while turning on the radio
and it will reboot the radio into the Reset Mode.
The radio Reset Screen will appear and ask you to Confirm the reset by pressing the Menu
2)
key on the front panel. The reset itself will take a minute or more.
3)
After completing the reset, the Calibration Date settings screen will open. You need to set the
correct information by using the Channel Knob. Pushing the Channel Knob will navigate through the
GMT, Date and Time fields, Rotating the Channel Knob will allow you to change the settings. When
finished setting the data, use the Menu button to Confirm and the radio will reboot.
4) After successfully resetting the radio, your codeplug will be gone and the factory smaller version
loaded. You should now load your saved Code Plug into the radio. Check the Com Port, and from the CPS
write your codeplug into the radio. No special set-up is required to write a codeplug into the radio.
D578UV Mobile Radio
Firmware Update Instructions
Radio Reset / MCU Reboot
http://tiny.cc/AnytoneDMR