AnyTone AT-D868UV 펌웨어 업데이트 절차 - 페이지 7

{카테고리_이름} AnyTone AT-D868UV에 대한 펌웨어 업데이트 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyTone AT-D868UV 8 페이지.
AnyTone AT-D868UV에 대해서도 마찬가지입니다: 펌웨어 매뉴얼 (8 페이지)

After making these changes, you are now ready to write this personalized code

plug to your radio. The first thing you should do is SAVE the modified file with a

unique name. Some people like to use a file name that included the date the file

was modified. To save your file with a unique name, click File and Save As.

Then type in a unique name, choose a location to save to and click Save, as

seen below.

Now that your file is saved, you can write it to your radio. Before you can read

from or write to the radio, you must install the Windows driver. This driver is

included with other files, each time a firmware update is released. This driver is

required for updating firmware, so if you have already done that, you've already

installed the driver. On the off chance you're only reading this section on

installing a code plug, install the driver. It's file name is

PC_cable_GD_VirtualComDriver 1.0.1.2118.

With the radio turned off (always have the radio off when connecting the USB

cable), attach the cable to both the radio and the computer. Turn the radio ON

and allow it to cycle through the Power-on Screen. Choose Set and Set Com.

From the drop down box that opens, choose the required Com Port (this is

usually the last one in the list). Then click OK.