AnyTone AT600 설치 매뉴얼 - 페이지 11

{카테고리_이름} AnyTone AT600에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyTone AT600 18 페이지. Mobile signal repeater
AnyTone AT600에 대해서도 마찬가지입니다: 설치 매뉴얼 (19 페이지)

AnyTone AT600 설치 매뉴얼

7. Repeater Installation

7.1. Installation requirements

7.1.1. Installation Location Requirements
1. The repeater shall be installed indoor in a cool, dry and ventilated room without erosive gas or smoke, or on a cool
and ventilated wall to ensure excellent heat dissipation.
2. Installation height should be sufficient for RF cable wiring, heat dissipation and maintenance.
3. Independent and stable power supply is necessary.
7.1.2. Power requirement
Generally AC 100~264V AC / 50±5Hz power supply is required.

7.2. Installation Steps

 7.2.1. Installation schemes
INSTALLATION STEPS
1. Find an appropriate position for an outdoor antenna. (see the requirements in 6.1. sect. )
2. Plug in the outdoor antenna to the mobile booster from BS side and fasten tightly.
3. Plug in the indoor antenna to the mobile booster from MS side and fasten tightly. (see the requirements in 6.1. sect)
4. Connect the signal booster to the Power Supply.
!Some models have an inbuilt Power Supply. Please, examine the manual applied to your model, if your signal
repeater kit doesn't include separate Power Supply, skip this step!
If the light indicator on the booster turns on it means the installation has been implemented correctly.
NOTE: Switch on the signal booster only after you connect outdoor and indoor antennas in the proper way!  
5. Test the signal of your mobile telephone – a maximum quantity of bars should be indicated on the display of your
phone in each corner of the location within booster coverage zone. In case the mobile signal is still instable try to
change the position of the outdoor antenna for more proper one. 
Important notes for installation:   
1. Cables from outdoor antenna should not be wound and be placed as straight as possible in order not to create any
hindrance for signal reception and its transmission. 
2. Cables should be shortened to the acceptable maximum so that not to waste or decrease mobile signal coverage
range.
3. In order to prevent water from coming into the mobile phone booster through the cable make a loop in it.   
4. Keep the outdoor antenna as far as possible from frequency aerials, high voltage cables, metal nets or transformers.
5. Never point the front of a Directional outdoor antenna towards the indoor antenna.