Dudley Classic 1L Auto Soap Dispenser 50310 설치 및 사용자 설명서 - 페이지 4

{카테고리_이름} Dudley Classic 1L Auto Soap Dispenser 50310에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dudley Classic 1L Auto Soap Dispenser 50310 6 페이지. Automatic soap dispensers

페이지 인쇄

Installation and User Guide

Automatic Soap Dispensers

Filling and refilling

Unlock the cover and hinge open.

Lift the lid of the reservoir and fill with your choice of consumable ensuring it is correct for the type

of pump supplied i.e. liquid, foam or hand sanitiser solutions.

Replace reservoir lid and close the cover ensuring the lock is engaged.

If new or empty, prime the dispenser by triggering the infrared sensor multiple times to ensure the

formulation reaches the nozzle ready for dispensing.

Fitting and replacing the batteries

The unit uses 4 x C Cell Alkaline Batteries, these are housed in the pump

section of the dispenser.

Remove the reservoir and lift the pump out.

Remove the back cover to gain access to the battery compartment. Fit

the batteries as per the image ensuring they are placed with positive

and negative ends in the correct place.

General Maintenance & Cleaning

Brushed Stainless Steel Units:

Clean with warm water and a soft cloth, wipe in the same direction as the brushed grain. Dry

thoroughly. DO NOT use soap, chemical cleaning detergents or abrasive cleaners.

Powder Coated Units:

Clean with a mild detergent and soft cloth. Ensure any detergent is fully rinsed off prior to drying

thoroughly.

Page 4