Anywave ATSC 140W 빠른 시작 매뉴얼 - 페이지 12
{카테고리_이름} Anywave ATSC 140W에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anywave ATSC 140W 13 페이지.
페이지 인쇄15. For Remote TX Monitoring and Control, you may network to the Exciter
REMOTE RJ-45 rear panel connection at 192.168.1.143 – you can change the
exciter ipaddress by navigating to the CONFIG submenu (simultaneously press
Left and Right buttons) and change the value of IP (please reference your
Exciter User Manual for details).
16. If using the Exciter Built-in remote web interface for remote control, please be
sure to set the Exciter to REMOTE mode (set CTL to RMT) before leaving the
transmitter site. The Remote/Local setting is located under the SYSTEM
submenu. Most of the Local TX controls are available on the remote web
interface, including On/Off, Raise/Lower power, etc. (refer to the Exciter user
manual for details).
ACT-140-QSG-DOC-V1.3, 09/29/2014
ATSC 140W TX Quick Start Guide
Page 12 of 13