Anywave PA-140W 사용자 설명서 - 페이지 8
{카테고리_이름} Anywave PA-140W에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anywave PA-140W 13 페이지.
페이지 인쇄
RJ45
Connector:
Note:
FWD
Connector:
Input Level:
Note:
REF
Connector:
Input Level:
Note:
Note:
1)
The back fan covers can also be removed to clean the air intake path. No screw driver is needed, and
no disassembly of the PA is required.
2 Specifications
Environment
Operation Temperature:
Operation Humidity:
Atmospheric Pressure:
Power Supply
Voltage:
Frequency:
RF Performance
Frequency:
VSWR:
Shoulder Level:
Note
1)
The electrical interface characteristics are measured at rated power. Values may change.
2)
Operating in abnormal conditions may result in damage to the equipment. Long operating hours in
severe environments may reduce the reliability of the entire system, which may cause permanent
damage to equipment. Make sure all electrical interface characteristics and environmental parameters
are within the defined range listed above before operating this equipment.
ACT-140PA-USR-DOC-V1.4, 09/12/2014
10M/100M Ethernet
For customers' remote control to the PA.
SMA
-20 to +10 dBm
External Coupler Forward sample for PA_FWD Power Meter.
SMA
-20 to +10 dBm
External Coupler Reflected sample for PA_REF Power Meter.
o
o
-10
C ~ +60
C (+14
20 % ~ 90 % (non-condensing)
86 kPa ~ 106 kPa
176 ~ 300 VAC (full load) / 90 ~ 176 VAC (half load)
47 ~ 63 Hz
473 MHz ~ 794 MHz
≤ 1.5
≥ 30 dBc (before pre-correction @ 140 W)
PA-140W User Manual
o
o
F ~ +140
F)
Page 8 of 13