DUDOFF DF-Z01 설치 및 사용자 지침 매뉴얼 - 페이지 11

{카테고리_이름} DUDOFF DF-Z01에 대한 설치 및 사용자 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DUDOFF DF-Z01 13 페이지. Built-in electric deep fat fryer

Before carrying out maintenance of any kind,

disconnect the appliance from the mains. All

maintenance must be carried out by authorized

personnel only.

6) PART REPLACEMENT

To replace components located inside the fryer the

resistance should be lifted up and secured in the

vertical position. Take out the oil kettle and loosen

the four screws that are under it (see fig. 10). The

work surface can now be detached from the

worktop giving access to all internal components.

To reassemble the work surface of the appliance

take care not to damage the power cables and

make certain that they are well positioned in the

Heating resistance

TYPE OF

CABLE

Policroroprene

H05 RN-F / H07 RN-F

MAINTENANCE

WARNING: MAINTENANCE MUST ONLY BE

PERFORMED BY AUTHORIZED PERSONS.

ELECTRICAL COMPONENTS OUTPUT

Name

TYPE AND SECTION OF POWER CABLES

FIG. 10

guides along the side of the appliance.

Note: in the event the power cord is replaced,

the ground wire must be left longer than the

lead wires (fig. 11) and the instructions in the

paragraph "ELECTRICAL CONNECTIONS" must

be observed.

To reassemble the appliance repeat the steps

above in the reverse order.

7) TECHNICAL SPECIFICATIONS OF

ELECTRICAL COMPONENTS

To facilitate the task of the installer a table with

component specifications is included below.

TOTAL OUTPUT

OF APPLIANCE

2300 W

2300

SINGLE - PHASE

POWER SUPPLY

Section 3 x 1.5 mm

FIG. 11