Duerkopp Adler 195 설치 매뉴얼 - 페이지 14
{카테고리_이름} Duerkopp Adler 195에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 195 14 페이지.
Duerkopp Adler 195에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지)
페이지 인쇄
Programming the Positions:
1.
Hold key P pressed.
2.
Switch on the main switch.
3.
For entry to the " Technician Level 1"
enter Efka Code-No. 1907 with the keys 1 ...0.
4.
Press key E.
5.
Enter parameter-no. F170 with the keys 1 ...0.
Press key E.
Press key F.
6.
Turn the handwheel one full revolution in the machine direction and
arrest in position A with the enclosed arresting pin.
Press key P twice.
7.
Press key P drücken.
8.
Press key E twice.
9.
Press key F.
Using keys + or - set the increment number 50.
10.
Press key E.
Using keys + or - set the increment number 190.
11.
Press key E.
Using keys + or - set the increment number 100.
12.
Press key E.
Using keys + or - set the increment number 240.
13.
Press key P twice.
14.
Attention!
It is essential that a seam be sewn with thread trimming and raising the
pressure foot. This is the only way for a setting to be definately stored in
the memory. Without sewing the setting is lost when the machine is next
turned off.
14
Code-No. C 0000 appears in the display.
Parameter- No. F100 appears in the display.
Service-Routine 1 (Sr1) appears.
Position 0 appears.
F170 appears in the display.
Service-Routine 2 (Sr2) and F171
appear in the display.
Position 1 and the set increment number
appear in the display.
Position 2 and the set increment number
appear in the display.
Position 1A and the set increment
number appear in the display.
Position 2A and the set increment
number appear in the display.
This completes the setting.