Duerkopp Adler 274 사용 설명서 - 페이지 8

{카테고리_이름} Duerkopp Adler 274에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 274 18 페이지. Preface and general safety notes
Duerkopp Adler 274에 대해서도 마찬가지입니다: 피팅 지침 (2 페이지)

페이지 인쇄

Element

16Separate drive

for edge cutter

17LED

18Switch for

edge cutting

19LED

20Key

21Key

22Key

23Key

24Key

25Knee lever

(only sub-classes -....41)

26Hook lubrication

Function

–

Two cutting rpms switchable (only 272-740142)

- Risk of Injury! -

Caution in the area of the edge cutter.

–

The blinking of the diode shows that the edge cutter

is operationally ready. To switch on and off the

following variants are available:

* Manual via key

* Via the sewing pedal through the run signal of the

sewing drive

* Automatic "On" or "Off" after a selected number of

stitches

* Automatic "Off" after thread trimming (See

Installation Instructions Section 13.)

–

I = Normal rpm

D = Drive "Off". Knife outside the sewing area

II = Increased rpm for greater stitch lengths and thick

materials

–

Indicator for main switch "On" (only 272-740142)

–

Beginning or end bartack on - Bartack off at the

control panel

Beginning or end bartack off - Bartack on at the

control panel

–

Single stitches

–

With sewing machine at rest: Needle up-down.

With sewing operation: Bartack (reverse sewing) at

desired position in the seam

–

Switching the edge cutter on and off. By sub-class

272-640000 the pneumatic operation Z124-401

(optional equipment) must have been installed.

Otherwise the key has no function.

–

Raise and lower the top feed roller manually.

Automatic lowering after a number of stitches see

Installation Instructions Section 12.

–

Before tilting the machine head to the back turn the

main switch off and remove the knee lever. To slip it

out conduct movements 1 and 2 and to hang it back

in movements 3 and 4.

–

The oil reservoir for the hook lubrication should not

drop below the "Min" mark.

By normal operation the oil level should be checked

weekly. Through the fill opening fill Esso SP-NK 10

oil up to the "Max" mark.

The oil flow for the hook lubrication can be regulated

at screw 5.