Anywire ARW-03 제품 설명서 - 페이지 11
{카테고리_이름} Anywire ARW-03에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anywire ARW-03 17 페이지. Address writer
Anywire ARW-03에 대해서도 마찬가지입니다: 시스템 제품 설명서 (6 페이지)
페이지 인쇄[Direct writing of addresses...DIRECT WRITE Mode]
The values become available at the time when addresses are written.
Check that power (in the case of 2-wire type, transmission signal) is supplied to the target unit in writing addresses.
In this mode, the values are updated at the time when addresses are written. Please carry out the operation
carefully because the address response changes and it may result in unexpected movement.
■Address writing operation
How to operate
1
Turn ON the POWER switch.
2
Press the SELECT switch.
Press the SELECT switch several
3
times to light the DIRECT WRITE display.
4
Press the SET switch.
5
Press the SET switch.
Display the address value to be written by
using the UP/DOWN switches.
6
If the R switch is operated, 50 addresses are
added. And if the number of addresses
added exceeds the maximum number of 250
or 500 (initial setting), it returns to 0 (zero).
Point the light emitting and receiving
part (yellow frame) at the address
7
setting port of the unit to be written
and then press the SET switch.
If moving to the next terminal to write
addresses, change the value by using
8
the UP/DOWN switches and repeat
writing operation with the SET switch.
9
In the case of failure in writing
Readjust the light emitting and
10
receiving part and
press the SET switch again.
- Clear the Err display.
- Switch the mode to another mode.
11
Press the CLEAR switch.
12
Press the L switch.
Press the SELECT switch
13
several times to light the display of
a desired mode.
14
Press the SET switch.
Return to Operation No.6
15
for rewriting operation.
After using ARW-03, keep the POWER switch pressed to turn OFF the power.
DIRECT WRITE (yellow)
Example)
Example)
Example)
Example)
READ (green)
WRITE (yellow)
DIRECT WRITE (orange)
-ARW03 11/17-
Display
After approximately
2 seconds, "SELECt" flashes.
Flashing
The writing mode is
determined.
Dot flashing movement
Display the set
address values
During the writing operation
Written address values
During the writing operation
Written address values
Err display
During the writing operation
Written address values
Return to the WRITE mode
display.
Dot flashing movement
Dot flashing movement