3onedata GW1101 series 사용자 설명서 - 페이지 2
{카테고리_이름} 3onedata GW1101 series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3onedata GW1101 series 4 페이지. Modbus
3onedata GW1101 series에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (3 페이지)
페이지 인쇄
1.
RS-232 Serial
2.
Ethernet port LED indicator
3.
Power LED indicator
4.
Serial receive data indicator
5.
Serial transmit data indicator
6.
Wall mounting installation
7.
10Base-T /100Base-TX Ethernet port
8.
DIP switch
9.
Power input 9~48VDC
GW1101-1D (RS-485)-P(9~48VDC)
1.
RS-485/422 Serial
2.
Ethernet port LED indicator
3.
Power LED indicator
4.
Serial receive data indicator
5.
Serial transmit data indicator
6.
Wall mounting installation
7.
10Base-T /100Base-TX Ethernet port
8.
DIP switch
9.
Power input 9~48VDC
【Appearance and dimension】
The shell size of the series is the same, but the type of the
interface is different. Unit (mm)
【Power supply input】
GW1101 series provide DC power input, voltage input is the
two terminal form, plug type 2 core spacing of 5.08mm terminals,
wherein the power input range of 9 ~ 48VDC. (V+, V-)
【DIP switch】
Top panel provide 4 bit DIP switch to set function(ON is
effective), 1, 3, 4 is hold, 2 is factory default, if you change the
DIP switch statue, please power off and power on.
【Communication connector】
The series products support 1 Ethernet ports and 1 serial ports
(RJ45 or 5 bit terminal interface).
10/100BaseT(X) Ethernet port
The pinout of RJ45 port display as below, connect by UTP or
STP. The connect distance is no more than 100m. 100Mbps is
used 120Ω of UTP 5; 10Mbps is used 120Ω of UTP 3, 4, 5.
RJ 45 port support automatic MDI/MDI-X operation. Can
connect the PC, Server, Converter and HUB .Pin 1,2,3,6
Corresponding connections in MDI. 1→3, 2→6, 3→1, 6→2 are
used as cross wiring in the MDI-X port of Converter and HUB.
10Base-T/100Base-TX are used in MDI/MDI-X, the define of Pin
in the table as below.
NO.
MDI signal
1
TX+
1
8
2
TX-
3
RX+
6
RX-
4, 5, 7, 8
—
Note："TX±"Transmit Data±，"RX±"Receive Data±，"—"Not Use.
MDI-X signal
RX+
RX-
TX+
TX-
—