Duerkopp Adler 506 사용 설명서 - 페이지 15

{카테고리_이름} Duerkopp Adler 506에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 506 17 페이지.
Duerkopp Adler 506에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (8 페이지)

4.2 Lubrication

For lubrication of the machine use only ESSO SP-NK 10 lubricating oil.

SP-NK 10 is available from DÜRKOPP ADLER AG sales offices.

Check the oil level in the oil reservoir of the oil mister

The run of the barrel shuttle is lubricated and cooled by compressed

air enhanced with oil from the oil mister.

–

The oil level in the oil reservoir 5 may not fall below the groove

marking.

–

If necessary top up the oil to the groove marking.

–

For this shut off the compressed air completely by turning the

knob 1 to the left.

–

For topping up screw out the oil filler screw 4.

–

After topping up set the operating pressure at 6 bar by pulling up

the knob 1 and turning to the right.

The set operating pressure can be seen on the pressure gauge 2.

Check the feed quantity of the oil mister weekly

–

Under operating pressure a drop of oil should drip out of the pipe

under the viewing glass 5 after every 2 to 3 work cycles.

–

Regulate the strength of the thus created oil mist at the setting

screw 3.