ANZ POS Mobile 2 빠른 참조 매뉴얼 - 페이지 4

{카테고리_이름} ANZ POS Mobile 2에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANZ POS Mobile 2 8 페이지.
ANZ POS Mobile 2에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (4 페이지)

CONFIGURING COMMUNICATION MODE

If you require your terminal to change communication modes between 3G, WIFI, IP or Dial-Up, please

follow the steps below.

Press <Func> 9, 9, 0, 5 and then press <ENTER>.

At "Swipe Merchant Card" Press <ENTER>.

Press <ENTER> to go to" COMMS MODE" Screen.

Press 1 to select Dial-up communication mode Press 6 to select GPRS communication mode Press 7 to select

IP communication mode.

Press <ENTER> until the ANZ Worldline Payment Solutions main screen appears.

How to Connect to WIFI Network:

Note: To connect to WIFI, ensure the Primary Comms Mode on the terminal is set to 7 – IP.

1. Press the right arrow key on the terminal

2. At Utility Function, type in 82077

3. Select Networks

4. Select New Network to scan for available networks

5. Select Automatic Scan

6. Select your desired network

7. Enter the WIFI password by using the letters and numbers on the keypad and press ENTER

Note: For special characters, press '0' repeatedly until you see the desired character.

8. The terminal will now display WIFI Network Connected

9. On the top left corner of the screen the WIFI Network will display.

Press <Func> 2, 4, 6, 8 <ENTER><ENTER>. "TMS Logon Successful" should display on the terminal.

Press <Func> 8, 7 <ENTER><ENTER>. "ANZ Initialisation Approved" should display on the terminal.

TERMINAL FAULTS – SELF HELP

If your terminal is experiencing technical issues (e.g. blank screen/screen is stuck) attempt the following

steps:

Press <Func> 8, 6 <ENTER><ENTER>. The terminal will Power Reset.

Press <Func> 2, 4, 6, 8 <ENTER><ENTER>. "TMS Logon Successful" should display on the terminal.

Press <Clear> to go to Main Screen.

Press <Func> 8, 7 <ENTER><ENTER>. "Initialisation Approved" should display on the terminal.

Press <Clear> to go to Main Screen. The terminal is now ready to process a transaction.

If unsuccessful please contact ANZ Worldline Payment Solutions on 1800 039 025 for further assistance.

Note: when terminal is not connected to the base, it can be switched off by pressing and holding the <Func>

and <Clear> key together. To turn on press <ENTER> key.

TERMINAL SECURITY

Please ensure that the terminal is placed in a secure location enabling the cardholder to use the keypad

without being observed by security cameras, CCTV devices or by any other person.

Only authorised ANZ Worldline Payment Solutions employees are permitted to install or perform

maintenance of your terminal.