Duerkopp Adler 550-16-26 사용 설명서 - 페이지 16
{카테고리_이름} Duerkopp Adler 550-16-26에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 550-16-26 19 페이지. Sewing lamp led
Duerkopp Adler 550-16-26에 대해서도 마찬가지입니다: 피팅 지침 (2 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
5.
Operating the Controls 550-16-26
6.
Sewing
Sewing cycle
V Before the start of sewing
Initial position
Positioning the material at
the seam beginning
Beginning the seam
Beginning bartack and continuing to
sew
At the middle of the seam
Interrupting the
sewing cycle
Continuing the
sewing cycle
Z Sewing an intermediate bartack
bartack
Changing the fullness value
At the seam end
Remove the material
The operating of the control is described in part 4:
"Programming instructions"
Operation / Remarks
- Pedal in rest position.
Sewing machine idle.
Needle up. Sewing foot down.
- Step half back on the pedal.
The sewing foot rises .
- Position the material.
- Release the pedal.
The sewing foot lowers onto the material.
- Step forward on the pedal and hold down.
The beginning bartack is sewn (if given).
Then the machine continues to sew at the
speed determined with the pedal.
- Release the pedal (rest position).
The machine stops.
The sewing foot is down.
- Step forward on the pedal.
The machine sews at the speed
determined
with the pedal.
- Press the key [OH] and hold the pedal down.
The machine sews in reverse as long as key [OH]
is pressed.
The speed is determined by the pedal.
- Operate the fullness key or left pedal.
The changed fullness value is activated.
- Step completely back on the pedal and hold down.
The end bartack is sewn (if given).
The thread is trimmed.
The machine stops in the 2
The sewing foot is raised.
nd
position.
1
19