Danby DDW2405BL 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Danby DDW2405BL에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danby DDW2405BL 13 페이지. Built-in
Danby DDW2405BL에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (13 페이지)

페이지 인쇄

INSTALLATION

INSTRUCTIONS

PREPARE HOTWATERLINE:

• The hot water line may enter from either side, rear or

floor within the shaded area shown in Fig. 6

• The line may pass through the same hole as the

electrical cable and drain hose. Or, cut an additional

1-1!2" din. hole to accommodate

the water line.

BEFORE YOUBEGIN

Locate and set aside the package containing the

2 Phillips Head Countertop Mounting Screws.

Shut-0ff 1-1/2" Din.

Valve

HOI_

[

Hot .= ==h_==

[iiiiii!

"4"

From [[,,!_d/,// 18' FromWall

Cabinet _ T/_/-_

.....

i v

'_ '---3" FromFloor

Cabinet Face-'-',

'Stainless

steel brGided

supply line

Figure 6

WATERLINECONNECTION:

• Turn off the water supply.

• Install a hand shut-off valve in an accessible location,

such as under the sink.

• The water connection is located on the left front side of

the dishwasher. Install the hot water inlet line, using a

braided flexible hose (available at most hardware

stores). Route the line as shown in Fig. 6 and extend it

forward at least 18" from the rear wall.

• Adjust water tank (heater) for 120 F to 150 F (49C to

65.5C) temperature.

• Flush water line to clean out debris.

• The hot water supply line pressure must be 20 ~ 120psi

CAUTION:

DO NOT OPEN THE DOOR UNTIL

YOU ARE READYTO INSTALL

THE DISHWASHER.

Opening the door will cause the dishwasher to tip forward.

If it is necessary to open the door, hold the top of the

dishwasher securely with one hand and hold the door with

the other hand.

STEP

1 CHECKDOORBALANCE

To check the door balance, hold the top of the dish-

washer firmly.

Decrease

Figure 7

• Open the door slowly, if the door drops when

released, increase spring tension. If the door

closes when released, decrease spring tension.

• Pull the spring adjustment pin out of the holes,

insert into the next highest or lowest hole and

test again.

• Adjust both door springs to the same tension.

• Continue moving the spring pin until the door

is balanced.