Duerkopp Adler 577-1111 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Duerkopp Adler 577-1111에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 577-1111 19 페이지.

General and Transportation Safety

2.1

3.1

Completing the table top

3.2

Setting the working level

NOTE !

The automatic sewing unit should be installed exclusively by a

properly qualified staff.

Remove the safety bands and the wood borders from the machine

head, from the machine table –

and from the stand.

–

Introduce the reel stand 1 into the borehole in the table top and

fasten by the available nuts and washers.

In case of not fully-assembled automatic sewing units:

–

Fasten the main switch 2 under the table top.

–

Fasten the electrical connection cables under the table top.

The working level can be set between 750 and 895 mm

(Measured up to the table top ).

In order to avoid a jamming of the stand, push the table top in and out

equally on both sides.

The scales on the sleepers can be used as adjustment aids..

–

Loosen the screws 3 on both sides of the stand.

–

Set the tabletop so that it is at the desired level and in horizontal

position.

–

Tighten both screws 3.