Danby DWC044 소유자 매뉴얼 - 페이지 4
{카테고리_이름} Danby DWC044에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danby DWC044 13 페이지. Danby dwc044: user guide
페이지 인쇄
SAFETY INSTRUCTIONS
ATTENTION
GROUNDING INSTRUCTIONS
This
appliance
must
the
event
of
an
grounding reduces the risk of electrical shock by providing
an escape wire for the electrical current. This appliance is
equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded.
WARNING
-
Improper
grounding plug can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if
the doubt exists as to whether the appliance is properly
grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your wine
cooler to extension cords or together with any other
appliance in the same wall outlet. Do not splice the cord.
IMPORTANT WARNING
An empty wine cooler is a very dangerous attraction to
children. Remove either the gasket, latches, lids or doors
from unused appliances, or take some other action that
will guarantee it harmless.
DON'T WAIT! DO IT NOW!
SPECIAL INSTRUCTIONS
You must remove the bottom door support on the bottom left
hand side of the unit before you can open the door. (See Fig. A)
FIG. A
be
grounded.
electrical
short
circuit,
use
of
the
INSTALLATION INSTRUCTIONS
Remove the exterior and interior packings, wipe the outside
thoroughly with a soft dry cloth and the inside with a wet, lukewarm
cloth. Avoid placing the cabinet in a narrow recess or near any heat
source, direct sunlight, or moisture. Let air circulate freely around
the cabinet. Keep the rear of the wine cooler 5 inches away from
the wall.
In
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the wine
cooler and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight may affect the
acrylic coating. Heat sources nearby will cause higher electricity
consumption.
To avoid vibration, the cabinet must be set level. To start
the wine cooler, follow the instruction below. The wine cooler
temperature will vary depending on the quantity of bottles stored
and on the frequency with which the door is opened.
SETTING THE TEMPERATURE:
1. Connect the power cord to a properly grounded outlet. Each
time the unit is disconneted and re-connected to a power
source, any previous "SET" temperature is erased and the unit
defaults to a factory setting of 10C (50F)
NOTE:
FLASHING LED = SET COOLING TEMPERATURE
STEADY STATE LED = INTERNAL CABINET TEMPERATURE
2. Set the desired cooling temperature by pressing the
"up/down" arrows adjacent to the thermometer icon. When
either button is depressed and released the "SET" temperature
will flash in the LED display for approximately 5 seconds. You
can only select (change) the "SET" temperature during the
flashing LED mode. Each depression of the up/down arrows
will increase/decrease the SET temperature by increments of
1 degree. The SET temperature can be adjusted from 6C ~
14C (43F ~ 57F) After the SET temperature is established, it
will continue to flash for 5 seconds then revert back to a
steady state LED mode. The steady state LED display will
gradually change, (increase/decrease) to reflect the true
temperature inside the cabinet.
2
OPERATION
LIGHT SWITCH
TEMPERATURE INCREASE
TEMPERATURE DECREASE
LED DISPLAY
FAHRENHEIT MODE
CELSIUS MODE
FAHRENHEIT/CELSIUS SELECTOR