Anzzi SD-AZ01-01 설치 매뉴얼 - 페이지 7

{카테고리_이름} Anzzi SD-AZ01-01에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anzzi SD-AZ01-01 10 페이지. Glass shower door

DRILLING

6. Place the completed frame on the shower base, threshold, or bathtub in its designated position. Carefully push the frame against the walls. Sometimes

the upper and lower wall opening measurements differ or the walls may not be plumb. To fix this problem, make slight adjustments by gently pulling the

Wall Profiles (04) out of the Glass Profiles (01) and use a leveler tool to adjust the vertically positioned frame.

7. This step will require an assistant to help hold the assembly in the proper position while drill holes are marked on the wall through the holes found on

the Wall Profiles (04) flange.

Carefully set the assembled unit to the side. Using a Ø 5/16" drill bit, drill the holes and insert the Wall Anchors (14). Add silicone caulk around the holes

in the wall, along the Wall Profiles, and under the bottom Guide Rail (02). Reposition the entire shower assembly back into its designated location and use

the Round Head Screws ST4x30 (14) to secure it to the walls.

Mark these

holes on wall