Duerkopp Adler N291 운영 매뉴얼 - 페이지 10

{카테고리_이름} Duerkopp Adler N291에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler N291 12 페이지.
Duerkopp Adler N291에 대해서도 마찬가지입니다: 설치 매뉴얼 (9 페이지)

페이지 인쇄

3. Operating the sewing machine

3.1 Threading the needle

thread

–

Turn off the main switch of the

machine.

Otherwise there is danger of injury!

–

Thread the needle as shown in the

figure.

3.2 Winding the bobbin thread

–

Slip the bobbin 4 onto the bobbin

winder 3.

–

Pull the thread through the guide 1

and the tension assembly 2.

–

Wind the thread clockwise approx. 5

times around the bobbin core and

tear off at the thread clamp 6.

–

Press the bobbin winder lever 5 into

the bobbin.

–

Sewing

The bobbin winder lever stops the

winding process, when the bobbin is

fully wound.

If the thread is not to be wound during

sewing, the foot must be locked in its

lifted position and the foot stroke must

be set at its smallest value.

3.3 Changing the bobbin

–

Turn off main switch.

Otherwise there is danger of injury!

–

Pull out the slide plate 7.

–

Remove the bobbin case cap 8 with

the bobbin 11.

To do this, grasp under the nose 10 of

the bobbin case cap.

–

Remove the bobbin.

–

Install the fully wound bobbin such

that the bobbin turns in the direction

shown in the figure, when thread is

drawn.

–

Pull the thread through the slot 16,

under the spring 14, through the slot

13, and from the inside to the outside

through the hole 12.

–

Install the bobbin case cap with the

bobbin and close the latch 9.

–

Push in the slide plate.

3.4 Setting the bobbin thread

tension

–

Turn off the main switch of the

machine.

Otherwise there is danger of injury!

–

Pull out the slide plate 7.

–

Remove the bobbin case cap 8 with

the bobbin 11. To do this, grasp under

the nose 10 of the bobbin case cap.

–

Turn the set screw 15 accordingly.

–

Install the bobbin case cap with the

bobbin and close the latch 9.

–

Push in the slide plate.