Anzzi SB-AZ013WL 설치 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} Anzzi SB-AZ013WL에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anzzi SB-AZ013WL 14 페이지. Shower base
Anzzi SB-AZ013WL에 대해서도 마찬가지입니다: 설치 및 관리 매뉴얼 (8 페이지)

페이지 인쇄

INSTALLATION INSTRUCTIONS

ATTENTION

The following steps are for the corner

●

shower tray.

STEP 1

Ensure that the floor and the studs

●

are at right angles.Provide a 5"×5" opening

in the subfloor for the drain.

The 2" PVC waste pipe should extend above

the surface of the sub-floor according to the

drain installation instructions and the height

of the Shower Tray.

Mark unit position on floor and through

●

drain opening.

Mark the locations of the studs on the flange

●

of the base.

These marks are used to verify base location

●

after drain is installed. (Fig 1)

The pipe height (A) shall be determined

●

according to the products on hand.

STEP 2

Place the tray into the designated position

●

so that the Drain Body drops around the

Drain Pipe and put the Shower Tray up

against the studs.

Level the tray and place marks on the studs

●

above the upper edge of the tile flange.

If the subfloor is not flat and level, use leveling

●

compound or mortar bed to ensure that the

base is level (shown in Step 5).(Fig 2)

90°

2" PVC Waste Pipe

(See Product Chart for Drain Location)

Fig. 1

Level base in two directions

Fig.2

(12.7 cm)

90°

(5"×5") Opening