Anzzi SD-AZ8076-01CHR 설치 및 운영 매뉴얼 - 페이지 10

{카테고리_이름} Anzzi SD-AZ8076-01CHR에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anzzi SD-AZ8076-01CHR 16 페이지. Glass shower door

This shower door must be mounted to a stud. Minimum threshold space is required.

IMPORTANT: Using a stud finder, ensure the wall intended to hold the door has a stud

at the installation point. A stud in this location must be identified to mountthe support

bar in order to proceed with the installation. If there is no stud in the shown area, we

recommend employing a qualified contractor to install one. (Fig 2.1)

Carefully remove the Corner Protector from the bottom corner of Fixed Panel [01] and

place Fixed Panel [01] on to the deck of bath tub. (Fig 2.2)

Note: Make sure to clean the deck before placing Fixed Panel [01] on it.

Gentlypush the Fixed Panel [01] to the wall. Use a levelto make sure it's plumb and level.

(Fig 2.2)

Adjust and push the Glass Supports [03] to the wall. Use pencil to mark the screw hole

location forAnchor on the wall. (Fig 2.2)

Install the Gasket and Anchor 2 of Fixed Panel Bottom Clip [11] to the Fixed Panel [01]

as the figure shows. Mark the outline of the Anchor 2 on the deck. (Fig 2.2)

Remove the Fixed Panel [01] and install the Corner Protector back to the bottom corner

of it. Gentlyplace it on the floor on acloth or blanket.