Duesenberg Les Trem II 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Duesenberg Les Trem II에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duesenberg Les Trem II 2 페이지.
Duesenberg Les Trem II에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Installed in minutes

- no drilling or routing necessary!

The Duesenberg Les Trem II is a small (but great) tremolo

system for guitars with tunamatic bridge and stop tailpiece.

Installation doesn't take more than a few minutes. And it

can easily be uninstalled, because no additional holes are

needed.

The tremolo is mounted in place of the stop tailpiece. Ins-

tallation is child's play. Inaccurate positioning is absolutely

impossible!

Important: The distance between the bolts is exactly 81.5

mm (center to center). This is a standard. The Les Trem II

only fits guitars that have this measurement.

Be sure to check this before installation!

Parts included:

1 Duesenberg Les Trem II incl. spring

1 tremolo arm

2 Mounting bolts, M8 threads

2 Mounting bolts, US threads

4 Washers

2 Allen keys (2.5 und 4 mm)

The four washers are supposed to increase the distance bet-

ween the tremolo and the guitar's surface to avoid damages.

The enclosed mounting bolts fit either M8 or US threads as

used on most American guitars.

Les Trem II

Mounting instructions:

1. Take off the strings and the stop tailpiece. Remove the

original bolts.

2. Screw the tremolo bolts (M8- or US-threads) into the

screw collars to test if they fit. Then remove them.

3. Now place the Les Trem II onto the screw collars and

check the gap under the tremolo. The tremolo should not

touch the guitar surface. If so (i.e. because the screw collars

are not high enough, or because the top is extremely cur-

ved), simply put one or both of the washers between the

tremolo and the screw collar.

4. After that, mount the tremolo using the fitting screws.

5. Tighten the bolts sufficiently! We strongly recommend

using the correct screw-driver. Otherwise you might

damage the screws' slots.

6. Push the tremolo arm through the arm holder so it's back

end projects about 5-10 mm. Tighten the Allen screws

softly with the 2.5 mm key.

7. String up the guitar and tune! It's important to tune the

strings now, because the strings' tension pulls the

tremolo towards the neck which changes the angle of the

tremolo arm.

8. Finally loosen the previously tightened Allen screws and

adjust the height of the tremolo arm to your requirements.

Now tighten the Allen screws firmly!

Done - have fun with your Les Trem II!