Anzzi ENVO WH-AZ011-M2 설치 및 운영 매뉴얼 - 페이지 8
{카테고리_이름} Anzzi ENVO WH-AZ011-M2에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anzzi ENVO WH-AZ011-M2 16 페이지. Electric instant water heater
페이지 인쇄
PRODUCT SPECIFICATIONS
Model
Voltage
Wattage
Rated Current
Min. required circuit breaker
Min. wire size (L1, L2, E)
Max. water pressure
Min. water flow to activate unit
Weight
Product Dimensions (D×H×W)
Water connections
Note: For supply connections, confirm using correct breaker size and wire gauge.
Connected only to a circuit that is protected by recognized ground-fault circuit
interrupter (GFCI).
INSTALLATION GUIDELINE
Make sure the appliance is intact, and the
●
fittings are complete.
Please make sure the main power supply,
●
water pressure, grounding condition,
ammeter and wire reach the standard of
installation requirement.
Clean all the impurities of the pipe by
●
allowing water to flow for a few minutes
before connecting the heater to the supply
line. Any residue or dirt in the pipes may
cause damage to the heater.
We strongly recommend installing a water
●
filter before the inlet of heater. Hard water or
water with high levels of minerals and alkali
can cause damage to this unit. Water
softening system is needed for this case.
PG.4
WH-AZ011-M2
240V
11000W
47.8A
60A
6 AWG
87 Psi (0.6 MPa)
0.53GPM (2 L/min)
9.04 lbs
2.76" x 14.17" x 8.66"
1/2''NPT
It must be fitted with a pressure reducing
●
valve adjacent to the entrance when the inlet
pressure is higher than 150 Psi (1034kPa).
DO NOT install near tinder or a strong
●
magnetic field. The appliance must only be
mounted with inlet & outlet pointing downward
VERTICALLY near by the water fittings.
Avoid locations that are prone to dampness,
●
high humidity, moisture, or dust.
WH-AZ146-M2
240V
14600W
60.83A
61A
4 AWG
10.65 lbs