Cascade 80R 사용자 설명서 - 페이지 10
{카테고리_이름} Cascade 80R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade 80R 18 페이지. Integral mount sideshifter, sideshifting fork positioner
페이지 인쇄INSTALLATION
Attachment Installation
4
Install forks (if required)
Shaft Mount Forks
A
Remove the backrest (if equipped).
B
Remove the cover plate.
C
Remove the fork shaft end cover.
D
Pull the shaft out of the frame far enough to allow
installing the fork tube on the shaft.
E
Engage the fork lower hook with the lower
carriage bar. Insert the shaft through the fork
tube. Fully engage the shaft in the frame and
install the end plate. Tighten the end plate
capscrews to the torque of 66 Nm.
F
Fasten the cylinder rod end to the fork tube
anchor. Tighten the nut to 320 Nm.
G
Reinstall the cover plate. Tighten capscrews to
the torque of 38 Nm.
H
Reinstall the backrest. Tighten capscrews to the
torque of 66 Nm.
Carrier Mount Forks
A
Remove capscrews and fork carrier outer retainers.
B
Remove locking pin from fork upper hook, if equipped.
C
Install forks using a pallet or blocks. Keep feet clear of
forks.
D
Reinstall fork carrier retainers and tighten capscrews to
165 Nm (lube torque).
A,D
Capscrew
Retainer
8
B
RH Fork Carrier
C
FP1364.eps
C D
IN0023.eps
Shaft Mount Forks
Carrier Mount Forks
200 mm
Wide Forks
A,H
B,G
F
E
IN0022.eps
6914838 EN