AOB ELECTRONICS B-12/7881 사용 설명서 - 페이지 4
{카테고리_이름} AOB ELECTRONICS B-12/7881에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AOB ELECTRONICS B-12/7881 8 페이지.
페이지 인쇄Instructions for use
Charging the internal battery
For best results, fully charge the unit before use.
Connect the USB cord to the port at the back of the speaker and insert the other end into
a port on your computer or other suitable USB outlet.
The LED will come on to show that the battery is charging. It will take around 3 hours to
fully charge the Battery.
LED indicator
There is an LED light located in the middle of the front speaker.
Status
Power off
Power on
Bluetooth pairing
Bluetooth paired
USB / SD mode
FM mode
AUX mode
Recharging the battery
Turn the speaker to Bluetooth pairing mode -
1. Turn the main power switch on the back of speaker to the "ON" position.
2. Wait 2~3 second until the light on the front starts blinking red and blue. This indicates
that it is in pairing mode.
Note: Bluetooth speaker will stay in pairing mode for a few minutes. If you are not fast
enough to complete the next step, simply turn "OFF" the speaker and then back to "ON"
position, and repeat step 2.
Pairing your device with Bluetooth Speaker –
Your SoundLogic Alien Speaker can wirelessly stream audio from any Bluetooth
enabled device within 8-10 meter. Simply follow the below steps.
1. Turn ON the device, LED lights will flash Blue and Red lights.
2. Turn on the Bluetooth on your Mobile Phone or Tablet or Computer
3. It will search for various devices
4. The name of our Bluetooth Speaker is "SL Alien". Pair it with this device.
5. If required, enter the password '0000' to confirm to finalize pairing.
Once paired, the flashing blue LED at around each 3 seconds
6.
LED
No LED
Blue and red LED glow for around 3 seconds
Blue and red LED flashing
Flashing blue LED at around each 3 seconds
Flashing blue LED at around each second
Flashing blue and red LED at around each second
Blue LED glow
Red LED glow
(Note: LED will not change color when fully charge)
4