Cascade 45C 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Cascade 45C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade 45C 6 페이지. Load push and load push/pull
페이지 인쇄A. Truck Requirements
l
Truck Relief Valve Setting: 2000 psi (140 bar), recommended.
2300 psi (160 barj, maximum.
0 Volume:
30C 3-15 GPM (11-56L/min.)
45C 3-10 GPM (11-37L/min.)
l
Recommended
hose and fitting size:
No. 6 (9/32 in./7mm, I.D.)
l
Truck carriage must conform to the IS0 dimensional
standard 2328, equivalent to Industrial Truck Association
(ITA) dimensional
standards as shown in chart.
0 Make sure the truck carriage is clean and the notches are
undamaged.
l
In order to conform to industry standard practice, the
hoses should be connected
to the truck auxiliary valve
as indicated
by the chart.
#7
Mounting
DkneMon
A-ITA (180)
Mlnlmum
Maxlmum
II
I
I
Clara
II
1 14.94 in. (38oOmm) 1 15.00 in. (381.0mm)
Cbo
Ill
18.68 in. (4745mm)
18.74 in. (476.0mmj
267%151/2
Function, In
iTZ%E%*
the opmtor.
Motion of the operator's hand
when actuatlng the truck ruxl-
lla
control handb whib
fat ng the bed.
7
Push/Pull
Pull (rearward)
Rearward or Up
Push (forward)
Forward or Down
I
2679.15112
B. Prior to Installation
0
Install the
Quick Change
lower mounting hooks. For
Bolt-On type hooks, proceed to Section C.
Quick Change Type A-
Install the components
as
shown. Tighten the capscrews to a torque of 105-115
ft.-lbs. (140-155 N.m).
(Right side shown
Quick Change-Type B-
a.
Install the guides to the baseplate
mounting holes with
the guide hole offset in the upward position-
5/8 in.
(16mm) from top of guide to hole center. Tighten the
capscrews
to a torque of 105-115 ft.-lbs. (140-155
N.m).
b.Slide the hooks over the top of the guides. Install each
locking pin through the hook lower hole.
5/8
in.
(16mm)
(Left side shown)
ook
Licking
Pin