Cascade E Series 설치 지침 - 페이지 2

{카테고리_이름} Cascade E Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade E Series 2 페이지. Push/pull and carpet pole removal and installation
Cascade E Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (14 페이지), 설치 지침 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (11 페이지), 운영자 매뉴얼 (20 페이지)

페이지 인쇄

Push/Pull Removal and Installation

WARNING: Keep hands and feet away from

pinch points and under the attachment.

Fully extend the faceplate. Lower the attachment onto a

pallet. Position the lower hooks over the edge of the

pallet to allow the hooks to slide down.

Disconnect the Quick-Change lower hooks. Pull out the

retaining pins, slide the hooks down and install the pins

in the hook lower holes.

WARNING: Before removing hoses, relieve

pressure in the hydraulic system. Turn the

truck off, then open the truck auxiliary valve(s)

several times in both directions.

Disconnect and tag the hoses at the carriage hose

terminal.

Lower the truck carriage and back away from the

attachment.

For installation, reverse the above procedures except for

the following items:

• Make sure the center locating tab in the upper hook

properly engages the center notch in the upper truck

carriage bar.

• The gap between lower hook and carriage bar must

not exceed 3/16 in. (5 mm). If gap is excessive,

remove the hook guides and turn them over. Tighten

the capscrews to a torque of 118-125 ft.-lbs.

(160-170 Nm).

• Slide lower hooks up and install the

retaining pins in the top holes to

secure the attachment on the

carriage.

Center on truck carriage.

Engage upper hook

centering tab in carriage

center notch.

NOTE: Install retaining pins

in the lower hook holes.

Disconnect and

tag hoses

3/16 in.

(5 mm)

maximum

PP0865.ill

c a

3-2003

Check lower

hook gap

Hook Guide

a d

s c

c a

AC0769.ill

Position attachment

on a pallet

PP0863.ill

Disconnect

lower hooks

PP0864.ill

PP0866.ill

Raise lower hooks

after placing on

truck carriage

5/8 in.

(16 mm)

Part No. 6029046-R1