Cascade Turnafork 45E 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Cascade Turnafork 45E에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade Turnafork 45E 14 페이지. Non-sideshifting & sideshifting clamps
Cascade Turnafork 45E에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (11 페이지)

페이지 인쇄

RUCK REQUIREMENTS

WARNING: Rated capacity of the truck/

attachment combination is a responsibility of the

original truck manufacturer and may be less

than that shown on the attachment nameplate.

Consult the truck nameplate.

Truck Relief Setting

2300 psi (160 bar) Recommended

2600 psi (180 bar) Maximum

Truck Flow Volume

Min.

20E, 30E,

5 GPM

40E, 45E

(19 L/min.)

Cascade E-Series Carton Clamps are compatible with SAE 10W

petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or

MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid

is not recommended. If fire resistant hydraulic fluid is required,

special seals must be used. Contact Cascade.

Flow less than recommended will result in reduced system

performance.

Flow greater than maximum can result in excessive heating,

reduced system performance and short hydraulic system life.

Carriage Mount Dimension (A)

Class II

14.96 in. (380.0 mm)

Class III 18.68 in. (474.5 mm)

GA0028.ill

Auxiliary Valve Functions

Check for compliance with ANSI standards:

GA0082.ill

Recommended

Max.

7.5 GPM

10 GPM

(28 L/min.)

(38 L/min.)

Minimum

Maximum

15.00 in. (381.0 mm)

18.74 in. (476.0 mm)

Tilt

Forward

Release

Sideshift

Hoist Down

Left

Hoist Up

Sideshift

Right

Clamp

Tilt

Back

ITA (ISO)

Carriage

Clean carriage bars and inspect for

damaged notches

GA0080.ill