Dugena 7000997 사용 설명서 - 페이지 7

{카테고리_이름} Dugena 7000997에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dugena 7000997 11 페이지. Radio-controlled clock
Dugena 7000997에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄

Further information and explanations can be found in the directions for

use.

2. Product features

• Radio-controlled DCF-77 clock with manual setting option/radio

reception in Europe.

• Can be used as a quartz clock outside the reception range.

• Transmitter call.

• Simple operation of all functions via buttons on the rear of the clock.

• Fully automatic change between winter and summertime and vice

versa within the reception range.

3. Technical data

Integrated radio receiver:

Aerial:

Reception sensitivity:

Batteries:

Typical life span with 1.5 V alkaline

LR 6 mignon battery:

Operating temperature range:

4. Scope of supply

1 radio-controlled wall clock

1 set of directions for use

Receiving frequency 77.5 kHz

Internal ferrite aerial

< 60 µ V/m

1 x 1.5 V LR 6 alkaline

mignon battery

< 12 months

0° C to 50° C

5. Radio technology

Radio technology is the most modern form of time transmission. With

good reception, a radio-controlled clock keeps very precise time and

need never be reset. With all radio-controlled clocks a deviation of just

1 second over 1 million years can be expected.

6. Commissioning

Your radio-controlled wall clock is operated with one 1.5 V LR 6 alkaline

mignon battery.

1. Insert the battery in accordance with the polarity marking.

2. As soon as your radio-controlled wall clock is supplied with power, it

is ready for operation.

3. Reading of the time telegram is fully automatic.

Once the battery is inserted, all hands move in overdrive to the

12 o'clock position. Once the radio signal is successfully received,

the hands will automatically be set to the current time. The clock

calibrates itself several times daily with the DCF-77 radio signal.

7. Manual time setting

Hold down the 'M Set' button on the rear of your radio-controlled wall

clock for longer than 3 seconds. By pressing the button now, you can

advance the clock to the right time in minutes. It is not possible to set

the seconds function manually. If the 'M Set' button is not pressed wit-

hin 7 seconds, the function is concluded and your clock will now conti-

nue to run as a quartz clock. When the clock is once again located

within the radio reception range of the DCF-77 transmitter, the hands

will automatically synchronise with the current time.