Dancutter DC SUPER FLEX 사용 설명서 - 페이지 5
{카테고리_이름} Dancutter DC SUPER FLEX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dancutter DC SUPER FLEX 20 페이지.
페이지 인쇄
4.0 Technical Description
Extremely flexible and user-friendly cutter that can work in
small pipes. The stainless steel frame contains 25 or 50 m
supply hose which the cutter is fixed direct on to. The supply
hose is supplying air, sprinkler and power to the cutter and is
used to push the cutter to the working position hereafter the
control of the cutter takes place on the supplied control Unit.
Working area is 70 - 150 mm / 3 - 6 in. In order to work in 150
mm the skip set, that is in the toolbox, have to be mounted.
The DC
SUPER FLEX has a built-in slip ring to the camera, which
allows 360° continuously rotation of the milling motor There is
also built-in lock and slip ring on the stainless steel frame, so
the cutter can freely be moved back and forth with the supply
hose, while working with and operating the cutter.
The camera has a side-mounted spray nozzle for cleaning
the camera lens, which is activated on the Control Unit, from
which the continuously rotation and forward/reverse move-
ment of the cutter is controlled by the two joystick. Cutter has
a built-in forward/backward movement of 60 mm. Raising
the milling motor is controlled also at one of these joysticks.
Specifications
External diameter: 60 mm, 2.4 in
Weight:
25 m: 58 kg, 128 lb
50 m: 71 kg, 156.5 lb
L: 1000 mm - B: 550 mm - H: 1030 mm
Control Unit
L: 350mm - B: 300 mm - H: 150 mm
In the event of new product developments, Dancutter reserves the right to change the technical description without advance notice.
There is a built-in 12.1 " color monitor in the lid of the control
unit. The cutter can move through two successive 45° bends
in a 75 mm pipe, and a 90° bend/angle of a relined 110 mm
pipe.
Wheels on the stainless steel frame, provides an easy and has-
sle free movement to and from the workplace. There are
mounted oil lubricates and water separator at the stainless
steel frame.
Max water content delivered by compressor per m
should be maximum: 20g/m
Cutting engine consists of an air motor, which runs at up to
15,000 revolutions per minute. It has an air consumption of
650 litres/minute and need 7 bar working pressure. The com-
pact cutters are made from a resistant stainless steel alloy
- which gives a minimum maintenance of the cutter.
The stainless steel frame measuring: Width: 550 mm. Length:
1000 mm. Height: 1030 mm.
Air motor: 15000 RPM
Air supply: 650 l/min, 22 cfm
Supply hose: 25 m or 50 m
Weight: 7 kg, 15.4 lb
supply air
3
.
3
Air preassure: 10 bar, 145 psi
Power supply: 110 / 220 VAC
Power supply: 24VAC
5