AOC 712s 제품 설명서 - 페이지 15

{카테고리_이름} AOC 712s에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AOC 712s 20 페이지. Aoc 712s lcd monitor specifications
AOC 712s에 대해서도 마찬가지입니다: 사양 (1 페이지)

페이지 인쇄

TECHNICAL SUPPORT (FAQ)

Problem & Question

Power LED is not on

No Plug & Play

Picture is fuzzy

Picture bounces or a wave

pattern is present in the picture

The power LED is ON (orange)

but there's no video or no

picture.

Missing one of the primary

colors

(RED,

GREEN,

BLUE)

Screen image is not centered or

sized properly.

Picture has color defects

(white does not look white)

Horizontal

disturbances on the screen

CLOCK (pixel frequency) controls the number of pixels scanned by one

horizontal sweep. If the frequency is not correct, the screen shows vertical

stripes and the picture has not correct width.

FOCUS adjusts the phase of the pixel clock signal. With a wrong phase

adjustment the picture has horizontal disturbances in light picture.

For FOCUS and CLOCK adjustment use "dot-pattern" or win 95/98 shut-

down mode pattern.

Possible Solution

*Check if the Power Switch is in the ON

position

*Power Cord should be connected

*Check if the PC system is Plug & Play

compatible

*Check if the Video Card is Plug & Play

compatible

*Check if the D-15 plug pin of Video

Cable is bent

*Adjust the Contrast and Brightness

Controls.

*Move electrical devices that may cause

electrical interference.

*Computer Power Switch should be in

the ON position.

*Computer Video Card should be snugly

seated in its slot.

*Make sure monitor's video cable is

properly connected to the computer.

*Inspect monitor's video cable and make

sure none of the pins are bent.

*Make sure computer is operational by

hitting the CAPS LOCK key on the

keyboard while observing the CAPS

LOCK LED.

turn ON or OFF after hitting the CAPS

LOCK key.

*Inspect the monitor's video cable and

make sure that none of the pins are

bent.

*Adjust pixel frequency (CLOCK) and

FOCUS or press hot-key (AUTO).

*Adjust

RGB color or select color

temperature.

vertical

*Use win 95/98 shut-down mode Adjust

CLOCK and FOCUS or perform hot- key

(AUTO-key).

The LED should either