3P Technik TCS5JBLA 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} 3P Technik TCS5JBLA에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3P Technik TCS5JBLA 6 페이지. Low-voltage top-up switch

Description Of Operation

The TCS5JBL Low Voltage Top-up Switch is intended to ensure the availability of water in a tank by

topping up the tank when the level becomes low, with a measured amount of mains water.

Water level in the tank is sensed via a float switch, and top-up of mains water is achieved via a

solenoid valve connected to the mains water supply.

The solenoid will be activated when the float switch reaches a downward angle of approx 45deg or

more, the top-up cycle will then continue until the float switch reaches an upward angle of approx

45deg, thereby ensuring a measured quantity of water is introduced to the tank and avoiding

unnecessarily frequent top-ups.

The float switch and solenoid circuits are both powered by a safe low-voltage, either 24Vdc

(TCS5JBL) or 24Vac (TCS5JBLA) with limited current and over-voltage protection.

Mains Voltage – There are exposed electrical conductors inside this appliance. This appliance must

be installed and serviced by a competent electrical technician to the current requirements of

BS7671 and IEEE recommendations. Before servicing this appliance, normal safe isolation

procedures should be implemented.

Do not touch any connection terminals while energised.

Do not attempt to service this item when wet, or in a wet or high humidity environment.

If the housing of the control panel becomes damaged, you must shut down and securely isolate

this appliance immediately.

TCS5JBL/TCS5JBLA Series Control Unit

2 x Male Connecting Plugs

The control panel can be mounted indoors or in sheltered outdoor locations (barns, covered areas,

etc). It is rated at IP66 and will not withstand persistent and direct rain, immersion, etc.

3P TCS5JBL/TCS5JBLA

Page 3

11/09/16