Danelectro Dan-Echo 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Danelectro Dan-Echo에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danelectro Dan-Echo 19 페이지. Tube amps

Dan-Echo

•

Connect instrument cable to the IN jack. Battery power is

activated when cable is connected to IN jack. Connect

amplifier cable to the OUT jack. If using Danelectro AC

Adaptor, connect to DC 9-Volt jack.

•

LED light will be on when foot switch is activated.

•

Control Functions:

MIX:

Use to select the mix of dry to echo/delay signal.

HI-LO:

Use to set long (Hi) or short (Lo) echo/ d elay times.

SPEED:

Use to select the length of echo/delay within the

HI or LO speed range selected.

REPEATS: Use to set the number of repeats.

HI CUT:

Cuts the high frequency on the delayed signal.

Each successive repeat suffers further high

frequency cut. This simulates a vintage tape

echo.

BATTERY: Uses one S-006P 9-Volt Battery. Danelectro "Vintage Power Source"

batteries are recommended.

Battery Eliminator: Uses 9-Volt battery eliminator. Polarity: Center negative (–) adaptor

plug. 300mA maximum. Danelectro Zero Hum

DE-1 I

NSTRUCTIONS

™

DA-1 Adaptor is recommended.

OLO

ELAY

MIX

HI-CUT

LO-HI

SPEED

REPEATS