Addie Water Systems TIG56SXT-S 매뉴얼 - 페이지 4

{카테고리_이름} Addie Water Systems TIG56SXT-S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Addie Water Systems TIG56SXT-S 19 페이지. Chemical free iron & sulfur reduction

페이지 인쇄

SYSTEM INSTALL AND START-UP

1. The Iron Genie will normally be installed after supply lines to the

outside(unless there is a reason to keep outside faucets iron-free) and after

neutralizing filter if needed(Calcite, Corosex)

2. All plumbing should be done in accordance with local plumbing codes.

3. Run piping from drain connection to an approved drain, following all local

codes. Secure the drain line! If distance is greater than 10' increase to 1"

drain line.

4. On the bypass, place in bypass position indicated by small pointer on

handle. Turn on main water supply.

5. SLOWLY place the bypass in service position and let water flow into the

mineral tank.

6. Open the nearest cold water faucet and allow water to run until the air is

purged from plumbing lines and discoloration is gone. Note: It is normal for

aerated water to appear effervescent.

7. Plug power cord into electrical outlet. Be certain the outlet has continuous

electrical power.

8. The display will light and show a time

9. Use the up or down arrows on the display to set the current time of day

10. Leave the unit in the service position. It is not necessary to run the unit

through the different cycle positions