DANFI AUDIO TE-012 사용 설명서 - 페이지 12
{카테고리_이름} DANFI AUDIO TE-012에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DANFI AUDIO TE-012 13 페이지. Suitcase style turntable
페이지 인쇄TROUBLE SHOOTING GUIDE
PROBLEM
GENERAL
No sound in general.
The unit does reset to
operation of any button
PHONO
No sound when playing
vinyl records
The sound is breaking up or
buzzing.
BLUETOOTH
No sound when playing
audio via Bluetooth
USB/TF
No sound in USB/TF mode
AUX
No sound in AUX mode
FM radio
No sound in FM radio mode
FM channel is not clear
POSSIBLE CAUSE
Volume not adjusted.
Source mode in wrong position.
Power cable disconnected or loose.
Under the influence of electrostatic
phenomenon, the product may
malfunction and require user to
disconnect
Volume not adjusted.
There are many dust on vinyl records
45RPM vinyl without use 45RPM
adaptor
There has obstacles when rotating
Your Bluetooth device has not been
paired properly.
The volume control of your Bluetooth
device is set at too low.
The volume control of the main unit is
set at too low.
Volume at minimum.
broken U-disk/TF card or
storage device is in NTSF
format
Volume at minimum.
External device not connected
properly.
Volume at minimum
The FM antenna needs to be
loosened.
REMEDY
Adjust the Volume knob.
Using the Mode button, select the proper
function as required.
Check the connection or the Power
cable.
Turn off the unit, disconnect the mains
plug, and reconnect after a few seconds.
Adjust the Volume knob.
Clean your records with an anti-static cloth.
Use 45RPM adaptor when play 45 RPM vinyl
records
Remove the obstacles and put the deviseon
a horizontal table or place.
Pairing your Bluetooth device according
to the Pairing name "TE-012"to a
Device Section. and playing Audio.
Increase the volume of your Bluetooth
device.
Increase the volume of the main unit to
turn to your wish.
Adjust the volume knob.
Clear contacts pins and connect again.
Change your U-disk to
format
Adjust the volume knob.
Clear contacts pins and connect again.
Adjust the volume.
Loosen the FM antenna back of side,
and adjust the external cable position to
get clear channel
FAT32 or FAT