Abtus AVS-1200C/V2 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Abtus AVS-1200C/V2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abtus AVS-1200C/V2 8 페이지. Multimedia controller

User Operation Guide

PROGRAMMING MODE

Serial

This allow configuration of Com3 communication parameter i.e. Baud rate, Data Bit,

Parity Bit and Stop bit of the controlled AV Switcher.

Default Parameter for AVS-1200SV2 is as followed:

Baud Rate: 9600

Data Bit: 8

Parity Bit: None

Stop Bit: One

Setting can be easily done with its individual drop list.

Bard Rate: 1200 to 115200

Data Bit: 7 or 8

Parity Bit: None or Odd or Even

Stop Bit: one

Layer

Notice that the Layer function is mask off, which means that Com Port 3 can only, allows

single layer command to be configured.

Hex Code

Command code entry for the relative button, only Hex Code is allows

Transmitter

Note that Com 3 ONLY allows Serial RS-232 transmission, No IR is allows in this case.

PROGRAMMING MODE

1.3 Infrared Tab

This allows user to configure/Learn the IR command code of the Controlled projector in the case where

RS-232 is not available.

1.4 Macros Tab

Macros allows any buttons/fucntion to be link to either Power ON or Power Off button after specific

delay time from 5 to 10 sec.

Example: After Power ON set projection screen Down with delay of 5 sec and set projector default

input select to VGA with another 5 sec of delay.