Danfoss AK-SC255 설치 매뉴얼 - 페이지 5

{카테고리_이름} Danfoss AK-SC255에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss AK-SC255 7 페이지. Com-trol local bus support
Danfoss AK-SC255에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (8 페이지), 사용자 설명서 (10 페이지)

페이지 인쇄

2.0 Programming AK-SC255 Database

One of the central tasks involved in retro-fitting the Com-Trol front end unit is the configuration of the AK-SC255 database that

allows the Danfoss controller to fully replace the Com-Trol unit(s). Review the following section for guidance in creating the

AK-SC255 database, which replaces the Com-Trol 4k2/4K2e systems.

Using the Com-trol EZCom software, pull back and save the existing Com-Trol 4K or 4K2e controllers to be converted to

the Danfoss AK-SC255

The Com-Trol files can be viewed with the Com-Trol EzSet software utility

Using the Danfoss AKA65 software service tool, create a blank database by using the simulate function. Ensure the correct

version of simulated database is created to avoid compatibility issues on site (i.e. use the same version for the database pro-

gramming that will be installed in the physical AK-SC255 unit)

Start configuration of the AK-SC255 database by setting the Legacy I/O type to COMTL (found in the Store Info /

Preferences) Figure 4

Configure the Modbus channel under the Communications / I/O Network / Rescan Channels page. If Danfoss AK I/O

boards are also to be used, ensure the channel 'LonWorks' is checked also. Figure 5

When assigning Com-Trol board points, first press F4 to convert the board-point type to the Com-Trol format. Figure 6

Relay configuration (table 1)

Table 1

Com-Trol format (EzSet)

Relay

Normal

Invert

Digital Input

Normal

Invert

Sensor offsets used in Com-Trol controllers should be transferred to the AKA65 database

Preferences screen

(set Legacy I/O to COMTROL)

Figure 4

Danfoss format (AKA65)

N-Closed

N-Open

Open

Closed

Rescan screen

(check Modbus)

Figure 5

Sensor Configure screen

(select from drop down type list)

Figure 6

new Com-Trol

sensor selection