2DI TV2 사용자 설명서 - 페이지 4

{카테고리_이름} 2DI TV2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 2DI TV2 4 페이지. Wireless sensors
2DI TV2에 대해서도 마찬가지입니다: 사용자 설명서 (3 페이지)

Setting the sensor alarms

6. Set the Alarm by highlighting the 'Set Alarm' button on the 'Sensor # Setup' screen

with 'Left' or 'Right' and touching 'Enter'.

7. Enable the alarm by touching 'Up' and then 'Enter'.

8. Set the trigger-alarm-time to any value between 0:00 and 99:00. This controls how

long the alarm and the relay will be activated.

Note: If you are using a dialer set it for at least 00:30 (30 seconds) but not

longer than 06:00 (Six minutes).

9. Scroll in the upper alarm temperature limit and delay time and then the lower alarm

limit and delay with 'Up' and 'Down' touching 'Enter' to move to each field in turn.

Note: The delay time is how long the temperature must remain above (or below)

the limit before the alarm occurs.

10. You do not need to enter the Calibration Menu at this time. (For calibration

procedures see the document Entitled 'Calibration Procedures' on the CD. It can

also be downloaded from our website http://www.e2di.com/PDFs/Calibration

Procedures.pdf)

11. Touch 'Escape' until you return to the Status Screen.

P O Box 159 • Crestwood, KY 40014 • (502) 243-0042 • (502) 243-0039 fax

You are done!

www.e2di.com

•