3rd Power DS 2 '65 Blackface 사용자 설명서 - 페이지 12
{카테고리_이름} 3rd Power DS 2 '65 Blackface에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3rd Power DS 2 '65 Blackface 17 페이지. Dream solo series 112 combo amplifiers & heads
페이지 인쇄Back Panel:
Speaker Outputs (C)
The 16-OHM SPEAKER OUTPUT is provided for connecting your amplifier to
standard 16 OHM speaker cabinet.
The 8-OHM SPEAKER OUTPUT is provided for connecting your amplifier to
single 8-OHM speaker, such as the internal speaker for the combo unit.
The 4-OHM DISCREET SPEAKER OUTPUTs are provided for connecting
your amplifier to single 4-OHM speaker cabinet.
SAFETY NOTES:
• Never operate your amplifier without a connected speaker cabinet. This
will damage your tubes or transformers - or both.
• Always operate your amplifier with the proper impedance output that
matches your speaker cabinets(s).
• In all cases, always use a good quality heavy gauge speaker cable (not a
shielded instrument cable) to connect your DREAM SOLO to the
speaker cabinet.
HybridMASTER™ (D)
The HYBRID MASTER control allows you to set the overall volume level of the
amplifier independent of the volume and tone settings established on the front
panel. This is a patent-pending circuit design developed by 3rd Power and is
available exclusively on Dream and Dream Solo series amplifiers.
Effects Insert (E)
The EFFECTS INSERT of the DREAM SOLO is designed to allow you to in-
sert an effects device (most often, time-based effects like delay or reverb) after the
preamp and before the power amp. When no effects device is present, this circuit
is completely bypassed to deliver a direct signal path between the preamp and
power amp stage.
12