Duke 59 Series 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Duke 59 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duke 59 Series 20 페이지. Ovens with “zp” control panel
Duke 59 Series에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (20 페이지)

페이지 인쇄

E. Oven Assembly

Before assembling and installing the oven, please check

to make sure that all necessary parts are present. In

addition to the oven itself, there will also be legs, feet or

casters. (For double sections, retaining clips, flue

connector and miscellaneous hardware.) Please check

the interior of all oven sections for the parts needed to

assemble and install your oven(s).

F. Leg Attachment

Once the oven has been removed from the

•

carton, lay it on its left side (the side

without the controls).

Hold the leg and align with the matching

•

holes in base and leg flange. Carefully

start the 5/16-18 bolts, (avoid cross-

threading), by turning clockwise and

tighten to the nearest full turn. A total of

(12) 5/ 16-18 x 3/4 bolts, flat washers and

lock washers are required to secure all

legs.

Once legs are secured, add two (2) storage

•

shelves between the four (4) legs. Secure

these by using the 1/4-20 x 3/4 self-

threading

screws.

carefully lift the oven to an upright

position.

To level the unit, raise or lower the adjustable feet as

required.

G. Caster Installation

Casters are available as an option for

•

double oven sections. They are packed

inside the oven for shipment.

To install follow same procedures as for

•

leg attachment. Position and secure the

casters to the four (4) insert nuts in the

base bottom.

They have 1/2-13 threads and will only fit

NOTE:

the large insert nuts in the bottom. The two

locking casters should be installed on the front

legs for easy access and better stability.

H. Double Sections

The necessary short legs, storage shelves and hardware

are shipped with these sections. Follow same

procedures for leg attachment as described above.

Once legs and shelves are in place and the oven is

placed in an upright position install the stacking

brackets that secure the top oven to the bottom oven.

The stacking brackets mount at the rear corners of each

After

completion

section. Remove the screws from the corner of the

oven that matches the holes in the stacking brackets.

Install the brackets with the new screws provided.

I. Adjustments Associated with

Installation

Each oven section and all its component parts have

been tested thoroughly and inspected before your oven

was shipped from the factory. However, it is sometimes

necessary to further test or adjust the oven once it has

been installed. Such adjustments are the responsibility

of the Dealer or Installer. These types of adjustments

are not considered defects, rather a normal and routine

part of the proper installation of the equipment.

These adjustments include but are not limited to:

adjustments and recalibration of the

•

thermostat

adjustment to the doors, leveling

•

and tightening of fasteners.

•

Note: No installation should be considered

complete without proper inspection and, if

necessary, any adjustments by qualified service

or installation personnel.