3S TE200 사용 설명서 - 페이지 2

{카테고리_이름} 3S TE200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3S TE200 20 페이지.

Always read these instructions before using the I/P converter .

！

WARNING：Indicates instructions that, if not followed correctly, "may lead to death

or serious injury".

！ Warnings

■Install the flame-proof version in compliance with the "New Guidelines for Industrial Electrical

Equipment Explosion-Proofing 1979" issued by the Industrial Safety Institute of the Ministry of

Labor and in accordance with "technical procedures that comply with international standards".

■The flame-proof version and Intrinsically Safe version and Nonincendive may not be installed or

used for hazardous applications using gases other than those applicable to the explosion-proofing

grade of the I/P converter.

■Perform adjustment (zero and span adjustment) of the flame-proof version in a non-hazardous

environment or after making the environment non-hazardous.

■Always turn off the power before removing the terminal box cover or main cover.

■If intending to remove or disassemble the pressure gauge for maintenance or other purposes,

always turn off the supply pressure and wait for the pressure in the pneumatic circuit to drop to

zero before undoing any screws or other fittings used to attach parts.

■Always turn off the supply pressure before replacing the pilot relay unit.

！

CAUTION：Indicates instructions that, if not followed correctly, "may cause a fault

or other physical damage".

！ Cautions

■Fit the I/P converter in the orientation shown in section 3.2

■As drain fluid or dirt in the supply pressure line may block the fixed orifice or cause misoperation,

fit a 5[micro]m or finer air filter (such as an SSS Mini-Set filter) and use a dryer or similar to

ensure a clean air supply.

■Using a lubricator on the supply side may cause a blockage in the fixed orifice or nozzle. Never use

a lubricator with this I/P converter.

Safety Precautions

0－0