DUKER 4510 Series 사용 설명서 - 페이지 4

{카테고리_이름} DUKER 4510 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DUKER 4510 Series 19 페이지. Resilient seated butterfly valves

Do not operate a valve whose permissible component operating pressure ("Ps") and maxi-

mum permissible operating temperature ("Ts") are not sufficient for the operating condition.

The area of application is marked on the valve.

Within the permissible operating temperatures, there is a risk of injury when working on the

piping components at temperatures below 10 ° C and above 40 ° C. Therefore, protective

measures should be taken in these cases.

Operating fluids must comply with the specification of the valve. The manufacturer assumes no

liability for corrosion damage caused by aggressive media. Failure to comply with this require-

ment can endanger life and limb and cause damage to the piping system.



The valve must be properly installed in the pipeline.



In the pipeline the usual flow velocities (e.g. according to EN 1074-1: 2.5 – 5 m/s for liquids must not

be exceeded in continuous service.



Abnormal operating conditions such as vibrations, water hammers, erosion, cavitation and greater

fractions of solids in the medium – especially wearing solids – must be clarified with the manufacturer.

2.3

Special risks

Before opening and/ or repairing valve, the pipe must be completely depressurized. The pipe

should be completely emptied before replacing wearing part

For valves used as an end fitting: In normal service a blank flange or a cover must be

mounted on the free pipe connection or the valve must be securely locked in the

"SHUT/CLOSED" position. Caution on closing such a valve: Beware of risk of crushing!

Issue 03

Düker GmbH – www.dueker.de

page 4