Duluth Forge EL1346C 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Duluth Forge EL1346C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duluth Forge EL1346C 10 페이지.

OPERATING INSTRUCTIONS CONT.

Button (N): Dimmer (Brightness Increase)

Push button N to increase the flame effect.

Button (I): Dimmer (Background Light Decrease)

Push button I to decrease background light, press once and the background light

decreases one level.

Button (O): Dimmer (Background Light Increase)

Push button O to increase background light, press once and the background light

increases one level.

Temperature Buttons – Increase (J) and Decrease (P)

This electric fireplace is equipped with a thermostat. Press the Temperature But-

ton J to increase the temperature. (The electric fireplace heater and fan will only

turn on if the temperature setting is higher than the room temperature. Heating

icon will light up while heating.)

Press the Temperature Button P to decrease the temperature. (The electric fire-

place heater and fan will turn off if the temperature setting is lower than the room

temperature. Heating icon will disappear.)

Timer Buttons – Increase (K) and Decrease (Q)

Push button Q to increase time, time will be increased by following sequence:

00-30-1H-2H-3H-4H-5H-6H-7H-8H-9H. Push button K to decrease time.

(NOTE: Timer is approximate and extreme caution is necessary when the electric

fireplace is left operating and unattended. Keep children, individuals and pets

away from the unit when in use.)

Button (L): °C / °F

Push button L to change the heat readout settings. °C for Celsius, °F for Fahr-

enheit. Corresponding icon will be shown on front screen after the button is

pressed.

NOTE: Digit and icon readouts on front screen will disappear if there has been no

user operation for 30 seconds. Press any button on the control panel or remote

control and icon readouts appear again.

CARE AND MAINTENANCE

WARNING: Disconnect power before attempting any maintenance or cleaning to

reduce the risk of fire, electric shock or damage to persons.

NOTE: If you need to leave for an extended time period, turn off the main power

switch and unplug the heater.

www.factorybuysdirect.com

M180017-1