Dulytek DW4000 사용 설명서 - 페이지 11

{카테고리_이름} Dulytek DW4000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dulytek DW4000 13 페이지. Heat press

INSTRUCTION MANUAL: DW4000

OPERATING INSTRUCTIONS

SETTING

CONTROL

PANELS

(continued)

PRESSING

Dulytek Equipment

www.dulytek.com

Press SET button again (Figure 10) to record all control panel's settings.

Repeat the steps 1 to 7 on the remaining control panel.

Figure 10

1. Wait until both platens heat up to the desired temperature(s). Tip: Digits

on the upper line of the control panel displays show the current tempera-

ture of the corresponding platen, and numbers on the bottom line - the

set temperature. The HEAT LED indicators will be lit while the press is

heating the platens (Figure 11). Once heating is finished, the indicators

are turned off, and the temperatures shown on both lines should be the

same.

2. Place the material you wish to press in the center of the bottom platen

3. Turn the wheel clockwise using the wheel handle

platen

and continue rotating it until the maximum pressure is reached.

4. Let off the wheel handle . The maximum reached pressure will be

maintained.

5. Press the timer button

displaying the countdown.

6. Wait until the countdown ends and the press beeps. The TIMER indicator

lights up (Figure 12).

7. Press the timer button again to turn off the timer. The TIMER indicator

turns off, and the beeping stops.

8. Rotate the wheel counterclockwise using the wheel handle

the press.

9. Remove the pressed material using heat resistant gloves or tools and

exercising extreme caution.

(continued)

Figure 11

to start the timer. The control panel

Figure 12

to raise the bottom

to release

PAGE 10

starts